If ink is NOT positioned over the drop detect opening, clean the Encoder strip and lubricate the Carriage rails and continue with step 8.Check the tape to see if ink is positioned over the drop detect opening.NOTE: The printer should fail the calibration or give System Error 0700xx when Drop detect opening blocked. Close window, and perform another Drop Detect calibration as outlined in previous steps.Place a piece of tape over drop detect sensor hole, pictured in Figure 1 below.Press the ACCESS PENS key, raise window as prompted when pen carriage is positioned at center of the printer.Press the PREVIOUS key until Ready, or Ready for media is displayed. If the Drop detect calibration fails, press ENTER.If the test passes, turn the printer Off and wait approximately 20 seconds before turning the printer On.The printer should display CALIBRATING while performing test. In the Service Test submenu, scroll to Drop det calib and press ENTER.Simultaneously press the ENTER and UP arrow keys to access the Service Test submenu.Press the ENTER key at the STATUS display.If the error re-appears, perform the Drop Detect calibration as instructed below.If no errors are reported on initialization, verify printer functionality by printing several internal prints.Close the window and turn the printer on.After cleaning, wipe dry with a dry lint-free cloth. If encoder strip is not damaged, clean thoroughly using a lint-free cloth dampened with water. Using a lint-free cloth dampened with water, gently wipe each rubber capping boot and wiper until clean.On the top surface of the capping station, locate the four small rectangular rubber-capping boots and rubber wipers.When the pen Carriage is in the center of the printer, turn the printer off and locate the capping station behind the left cover. Press the ACCESS PENS key on the front panel.If any pen(s) are defective, remove and clean the electrical contacts on the pens and the Carriage using a lint free cloth dampened with water.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |